The Powder Toy

Logic's Laser V1 by LogicAndAspiration

LogicAndAspiration
LogicAndAspiration
35 / 24
29th Nov 2012
21st Dec 2012
My first laser. I've been fine-tuning it on and off for a day, and now it's protected against most reasonable threats like molten metal or reflected photons, doesn't malfunction as far as I see, and melts almost anything I put in front of it.
melter veryhot ololo averagelaser blablablabla

Comments

  • legomaster
    legomaster     30th Nov 2012
    how is this different to any other laser
  • longinuspun
    longinuspun     30th Nov 2012
    you can look at my laser and see how i did it. my save id is 1007689
  • longinuspun
    longinuspun     30th Nov 2012
    you need to make the layers thicker around the pscn/nscn because photons can go through one layer of some material. Try using two layers of void, or one void and one diamond. that might help.
  • Rainmaker51
    Rainmaker51     30th Nov 2012
    @Logic: It is a good laser, but it just needs a little fine tuning
  • Rainmaker51
    Rainmaker51     30th Nov 2012
    @Logic: change out some of the dmnd around the p/nscn to insl, so the reflected phot wont superheat the dmnd and melt the electronics
  • PTuniverse
    PTuniverse     30th Nov 2012
    Why is this on FP? It's just a basic laser...
  • Webdude53
    Webdude53     30th Nov 2012
    Ah, now I see why there is dead life there.
  • cyberdragon442
    cyberdragon442     30th Nov 2012
    PS...+1...Melts @#$%.
  • cyberdragon442
    cyberdragon442     30th Nov 2012
    No it just shorts. -_-
  • hdp
    hdp     30th Nov 2012
    if u make it elec it will make it ten times hotter