The Powder Toy

6 Cylinder Puffmaker by Stefeez323

Stefeez323
Stefeez323
73 / 28
5th Oct 2013
6th Oct 2013
Simple, more compact than the original 4 cylinder puffmaker (I did not make the original), this was made from scratch; I did not copy-paste anything from the original creator, outi. I just used a very similar concept.
cylinder engine mechanics puffmaker puff simulation

Comments

  • Stefeez323
    Stefeez323     7th Oct 2013
    Demoman200 that would make the exhaust width too small and actually make the pressure and gasses come out very slowly and clog up.
  • waleed123
    waleed123     7th Oct 2013
    id:1334822 check it out stefeez232
  • waleed123
    waleed123     7th Oct 2013
    check my 18 cylinder puff maker:)
  • Demoman200
    Demoman200     7th Oct 2013
    Very good! You should add some DMND to the slopes, though, so that the fire and pressure come out smoother.
  • waleed123
    waleed123     7th Oct 2013
    upload it again :)
  • Stefeez323
    Stefeez323     6th Oct 2013
    ID:1334121 Here is the tractor.
  • Stefeez323
    Stefeez323     6th Oct 2013
    Also, I fixed the engine in the middle, it has 2 exhausts now, however I had to move other engines and adjust the exhaust on the 1cyl one.
  • Stefeez323
    Stefeez323     6th Oct 2013
    "Don't advertise for your save in your save" errr.... Sorry, just noticed that..
  • Stefeez323
    Stefeez323     6th Oct 2013
    ID:1333912 CHECK IT OUT IT'S AWESOME!11!eleven! And it was a b**** to make...
  • Stefeez323
    Stefeez323     6th Oct 2013
    Err.. I know, that's why it's the engine for commercial use made for road cars, I could add fans, which I don't want to, or I could remove the muffler thingamajic, then it would be a racecar engine.. It's a safety rev limiter. Also the tractor is gonna be up in 1 minute, it's my absolute best creation by far!