The Powder Toy

SOLID PRINTER. by iamdumb

iamdumb
iamdumb
50 / 5
15th Jul 2014
19th Jul 2014
I think WIFI is cheating. Using that element to teleport SPRKs around the simulation seems like cheating to me. Seems easy enough to make a solid printer without using any of it.
simple unique gtech printer electronics nowifi photocopier

Comments

  • Butcandy47
    Butcandy47     16th Jul 2014
    May I use your output and reverse-engineer my own from it?
  • Butcandy47
    Butcandy47     16th Jul 2014
    TIME TO MAKE A FULL PRINTER :DDDDD
  • Butcandy47
    Butcandy47     16th Jul 2014
    OHHHHHHHKKKK THANK YOU
  • iamdumb
    iamdumb     16th Jul 2014
    When error-checking, set a DLAY of 40 frames or so and cycle through your printer frame by frame. Add small delays where nessecary and then make the delay shorter. eventually, You'll manage to do it without DLAY (like in this example). BTW, it is really satisfying when you finally finish and it actually works and prints something :).
  • iamdumb
    iamdumb     16th Jul 2014
    It's all about your timing :)
  • iamdumb
    iamdumb     16th Jul 2014
    use INST SPRKed CRAY to transfer the current line on top of the PSTN. Then use INST SPRKed CRAY to fill the rest of the line up with another material. Push the PSTN on the FRME with TMP non-zero and then continue with the next cycle after pulling it back.
  • Butcandy47
    Butcandy47     16th Jul 2014
    Hey, can anyone tell me how to make the actual printing part (the output bit)? Cause I have made the scanning(?) part, but no matter what I do, I cant make a WORKING output.
  • iamdumb
    iamdumb     16th Jul 2014
    @dom2mom, Thank you. @weapon-man I would probably have to build a new one :(. Here, I would probably only be able to set the colour for the entire print.
  • dom2mom
    dom2mom     16th Jul 2014
    @iamdumb, You are not dumb, you are derp. Derp is good. Be proud derp.
  • sumthin_man
    sumthin_man     16th Jul 2014
    This is cool +1, although it slightly copies my design.