The Powder Toy

29-bit PHOT-Transmitter by NoVIcE

NoVIcE
NoVIcE
162 / 8
2nd Feb 2017
24th Feb 2017
Sending FILT 29-bit data through photons. That is something cool, i think. I hope you like it. Comments are appreciated. Make sure to reset before resending. ** Its Updated Again**
transmitter phot electronic send receive novice transmit filt 29bit electronics

Comments

  • apple5265
    apple5265     3rd Feb 2017
    simulate the new tech called lifi
  • the_new_powder99999
    the_new_powder99999     3rd Feb 2017
    If you want to speed up the transmitter, replace the FILT on top with a pixel before the QRTZ, it can be removed by using PSCN with DRAY to put the next FILT in the same spot.
  • the_new_powder99999
    the_new_powder99999     3rd Feb 2017
    Photons with a life of 15 and a speed of 50fps should allow them to be detected by a single detector with a tmp of 25.
  • NoVIcE
    NoVIcE     3rd Feb 2017
    However*
  • NoVIcE
    NoVIcE     3rd Feb 2017
    Ah, yes. Well, it is still limited by the fact that even fast photons arent solution because they can 'skip' the detector. Howevery I can somehow make the sender preparation faster.
  • the_new_powder99999
    the_new_powder99999     3rd Feb 2017
    It is 10+ seconds because the PHOT life is about 600, at any point during its life it could rebound into the reciever. If there were two signals within 600 frames the first signal could block the second signal.
  • NoVIcE
    NoVIcE     3rd Feb 2017
    @the_new_powder99999 It needs about 3.5 seconds at roughly 60fps. And with this you can make a piston bot make several moves that can take more than the new transmssion preparation. But FPS doesnt matter, as the speed rate, and its proportions relative to all objects in TPT matters, not the rate of the visual output.
  • NoVIcE
    NoVIcE     3rd Feb 2017
    @TobyM88 - Well, its exactly like that, its sent before receiving, and resetting is manual, so it is and can be after evertything. Or I didnt get what you said?
  • the_new_powder99999
    the_new_powder99999     3rd Feb 2017
    You have to wait 10+ seconds between transmissions at the moment, which is slow, even for a piston bot using the information efficiently. Increasing the speed (And decreasing the life value) of the photons is really the only way to speed up the transmission rate.
  • TobyM88
    TobyM88     3rd Feb 2017
    If you could somehow make the wire delayed enough for it to send before resetting, yet before recieving.......