35 / 2

1st July

21st September

This is my first reactor, it is an RBMK reactor that i genuinely tried, it has automatic rod regulating systems, It has state of the art Safety Systems, Working Controls, A fully closed feed loop, Two turbogenerators and Does "not" Explode.

rbmk realistic detailed reactor chernobyl

Comments

Thatguywholikestrain 2nd July

You can copy and modify anything! feel free!
Thatguywholikestrain 2nd July

hope that helps :)
Thatguywholikestrain 2nd July

Also remember to surround the fuel assembly with steam channels around it no space between the assemblies. leave one pix wide gap for the pipes to create their own brck
Thatguywholikestrain 2nd July

now you have a good reactor core. if you wanted to pipe the steam to the turbine, just pipe the steam coming from the Steam drums ( The hollow sphere on top of the heat exchangers ). And run place a low pressure and high pressure turbines here and there and pipe the output to a condenser. then feed the condensed steam into the steam drums again so the water that turns to steam doesn't run out.
Thatguywholikestrain 2nd July

runs and exchanges heat with the heat exchangers, the coolant water that is turned to steam and it's heat exchange between the feed water, will turn into water back again, then it will go down through a pipe into a MCP ( Main Circulation Pump ) it will be then piped into the first steam channel pipes. (Remember to put the MCPs on both sides below the heat exchangers)
Thatguywholikestrain 2nd July

then add a hollow sphere on top of the heat exchangers, and add some Feed water. this feed is the one that will be turned into steam for the turbines, after the reactor coolant water, (the water that runs through the core)
Thatguywholikestrain 2nd July

after like 5 or 6 Copy and pasted you will now have a reactor core. run the pipes into two heat exchangers. (Remember to divide the pipes into left and right. these pipe go into heat exchangers.
Thatguywholikestrain 2nd July

after that add a 3 pix frme at the bottom of the control rod, then in the bottom middle add 2 pix pstn then one space away from the pstn on the left side put nscn and on the right side pscn. now you have a working control rods to control the uran.
Thatguywholikestrain 2nd July

then after that, Build a control rod (pump) if using uran as fuel, then from the bottom of the fuel rod, start a 3 pix wide crmc frame, then extend it downwards upto how long your fuel rod is ( can be any length )
Thatguywholikestrain 2nd July

first just build a fuel assembly. then from the bottom build a steam channel, then build it to the top the channel

The Powder Toy

RBMK reactor that i made by Thatguywholikestrain

Comments