@TachyonIndustries (View Post)
We can attach the controls to an OR Gate, that way the logic gate can allow it to support STKM and SPRK based controls.

COULD SOMEONE PLEASE EXPLAIN WHAT A LOGIC GATE IS!!!!

@Wazabi-Bros (View Post)
A logic gate for example lets say an AND gate is a peice of electric or mechanical chunk that makes it where you need 2 things too activate it so an or gate is any switch will activate i used them in Minecraft and when i was a bit younger lbp

Ahh thakyou

Wow im making good progress... So far what i have found out is that you can make about a playing area about 50 pixles wide. you need 50 to make a point and 50 to earase each of those points. Since our wifi is only limited to 93 pixles we will have to be conservative. If we want to make it bigger we could just blow it up and make each pixle into a 4X4 pixle. that would double our playing area to 100 pixles.

The paddle would be 2 pixles thick and maby 6 inches wide.

Somehow we could use a logic gate to just add on 2 vertical pixles to one side and cut off the 2 from the other side. Depending on wich way you are going.

Im really close to getting a version you guys can look at, then maby you can understand what i just said lol!

Here is the concept. The next step will be to add erasers, and then to make the logic gate. Also, array goes through powered SWCH, but PHOT does not. we can use this to deflect a missed photon somewhere where it can be rigistered without being shot at by arrays. A generator wall should do fine to detect it.

i slept for a good 6 hours, and in my dreams i learned how to wire the logic gate. It is so simple.... I will be back shortly.