Difference between revisions of "Element:DRAY"
| Line 38: | Line 38: | ||
}} | }} | ||
| − | When powered, this element copies what is in front of it. By default this will usually double whatever it is copying, but you can set its | + | When powered, this element copies what is in front of it. By default this will usually double whatever it is copying, but you can set its tmp and tmp2 to refine how it copies. When sparked by INWR, it doesn't copy diagonally. When sparked by PSCN, it will replace existing particles when placing the copy down. Setting the .tmp to a non-0 value will copy that amount of pixels (instead of stopping at an empty space). Setting .tmp2 sets how much space to leave between each copy. Changing .ctype sets which element to stop copying on (instead of empty space). |
{{Languages}} | {{Languages}} | ||
[[Category:Work in progress]] | [[Category:Work in progress]] | ||
Revision as of 19:44, 21 June 2016
| Properties | |
|---|---|
| Section | Electronics |
| Spawn temperature | 22°C |
| Heat Conductivity | 0% |
| Relative weight | 100 |
| Gravity | 0 |
| Acid dissolve rate | 0.1% |
| Flammability | 0 |
| State | Solid |
| Misc properties | |
| Source code | |
When powered, this element copies what is in front of it. By default this will usually double whatever it is copying, but you can set its tmp and tmp2 to refine how it copies. When sparked by INWR, it doesn't copy diagonally. When sparked by PSCN, it will replace existing particles when placing the copy down. Setting the .tmp to a non-0 value will copy that amount of pixels (instead of stopping at an empty space). Setting .tmp2 sets how much space to leave between each copy. Changing .ctype sets which element to stop copying on (instead of empty space).
| Language: | [[::Element:DRAY|English]] |
|---|
