Difference between revisions of "Elements:Electronics"
(Created page with "This category contains lots of elements that react with spark to perform drastic changes in their behavior, or different ways to transfer an electric current to other electronic ...") |
(No difference)
|
Revision as of 20:18, 28 September 2011
This category contains lots of elements that react with spark to perform drastic changes in their behavior, or different ways to transfer an electric current to other electronic conductors. Most have unique properties that are very useful.
Contents
- 1 Metal [METL]
- 2 Electricity [SPRK]
- 3 P-type silicon [PSCN]
- 4 N-type silicon [NSCN]
- 5 Negative Temperature Coefficient Thermistor [NTCT]
- 6 Positive Temperature Coefficient Thermistor [PTCT]
- 7 Electrode [ETRD]
- 8 Battery [BTRY]
- 9 Switch [SWCH]
- 10 Insulated Wire [INWR]
- 11 Instantly Conducts [INST]
- 12 Wifi [WIFI]
- 13 A-type ray [ARAY]
- 14 Mercury [MERC]
- 15 Wire [WIRE]
Metal [METL]
Transfers charge, melts. Basically copper in behavior. Melts into [molten metal] at 1000C/1273.15K
Electricity [SPRK]
A single spark of electricity. Not an actual particle, it's only visible on conducting elements. Heats up certain conductors.
P-type silicon [PSCN]
Transfer current to all conductors regardless of rules. Melts into [LAVA] at 1400C/1687K. Put a 1-pixel thick layer of PSCN followed by NSCN to form a simple solar panel. Generally used to activate powered materials or in diodes.
N-type silicon [NSCN]
Will only conduct based on the receiving elements rules and does not conduct to PSCN under any circumstances. Generally used to deactivate powered materials or in diodes. Melts into [LAVA] at 1400C/1687K
Negative Temperature Coefficient Thermistor [NTCT]
Basically will conduct electricity if above 100C/393K. Among its special conductive properties is the ability to cool itself to about 22C. Melts into [LAVA] at 1400C/1687K.
Positive Temperature Coefficient Thermistor [PTCT]
Basically will conduct electricity if under 100C/393K. Melts into [LAVA] at 1400C/1687K. Among its special conductive properties is the ability to cool itself to about 22C.
Since it has the ability to cool itself to about 22C, it is very useful to demonstrate the process of evaporation.
Electrode [ETRD]
When energized finds the nearest electrode and creates a line of plasma between them and transfers the charge. Caution: Use literally 1 pixel of it per electrode, not entire blocks. Otherwise this will create an awful lot of plasma which is usually very laggy.
It will keep looping if you use more than 2. Electrode will not fire to an adjacent electrode if Insulator [INSL] is directly in the center of the two. Walls will not affect the plasma or transfer.
Battery [BTRY]
Passes electrical charge to Metal [METL], P-Type Silicon [PSCN] and N-Type Silicon [NSCN]. Boils into Plasma [PLSM] at 2000C/2273K.
Switch [SWCH]
Conducts electricity when sparked by PSCN, stops conducting when receives spark from NSCN. When a spark transmits downward or to the right through SWCH, it conducts instantly (like INST), when going up or leftwards, it only conducts slightly faster than metal. SWCH is dark green when off, bright green when activated.
Insulated Wire [INWR]
Doesn't conduct to metal or semi-conductors. Only transfers [SPRK] to/from [PSCN] and [NSCN].
Melts into [LAVA] at 1400C/1687K.
Instantly Conducts [INST]
Conducts sparks instantly, PSCN to take, NSCN to remove. Indestructible except for BOMB. Dark grey in colour.
Wifi [WIFI]
Destructible by ACID and pressure, wireless conductor. Receives spark from any conductive material (with the exception of NSCN) but only NSCN, INWR and PSCN can receive the spark from WIFI. There are 99 frequencies to use, all of which are 100 degrees apart. (PSCN was added in 44.7)
Breaks into BRMT, or broken metal at a pressure of 15.
For further usage, check here: WIFI
A-type ray [ARAY]
Indestructible (44.7), can receive a SPRK from all of the electric conductors, even SWCH. It creates a line of the element BRAY in the direction opposite to the side it was sparked from. But ARAY responses to sparks only 2 frames after the BRAY fully disappeared. Unlike other electronics, ARAY must receive a SPRK from a pixel in direct contact with it.
For For further usage, check here: ARAY
Using PSCN to spark ARAY will make BRAY that will erase any normal BRAY. It does mostly the opposite of normal BRAY. It will spark metal and does not fade out slowly. Bray can pass every wall.
Mercury [MERC]
Added in version 50.6, Mercury is a liquid that conducts electricity. When heated up, this liquid expands. Does not kill STKM. This is one of the heaviest liquids. It sinks below lighter powders liquids.
Wire [WIRE]
Added in version 55.9, Wire is a solid conductible element based on another game known as WireWorld. WIRE is indestructible (excluding BOMB.) WIRE accepts SPRK from PSCN and gives to NSCN. WIRE works on the same principles as GOL, simple mathematical rules applied cause generation of four different states; Empty, Electron Head (blue), Electron Tail (white), and Conductor (orange). The rules it follows are:
- Empty → Empty
- Electron head → Electron tail
- Electron tail → Conductor
- Conductor → electron head if exactly one or two of the neighboring cells are electron heads, or remains Conductor otherwise.
(Please note that one "cell" is one pixel)
WIRE is extremely useful for logic gates, and has many other electronic applications. For example, entire computers (albeit, large ones) have been created made entirely out of WIRE.
For further instructions on how to use Wireworld Wires please go to http://karl.kiwi.gen.nz/CA-Wireworld.html or http://www.quinapalus.com/wires0.html