The Powder Toy

Need help with an issue... by King36C

King36C
King36C
3 / 0
12th May 2019
25th May 2019
Well. I worked a little on this reactor and i changed a lot of things. Do you like it design ? I do but i don't know if i should let thoses 3 wires like that or if i should make a steam device to produce direct energy. thx for any answers/sugestions. :)
pcln help needhelp uran boyl reactor improve king36c workinprogress

Comments

  • Zuriel
    Zuriel     22nd May 2019
    Good job! I was trying to make refrigerant gas reactors,but i had the exploding problem with amdient heat on,and you managed to take it under control.
  • King36C
    King36C     18th May 2019
    To complete what i said in the description i don't know if making energy with TSNS seems "legit" or not enough complicated. Do you think i should let this type of system or should i make something different, like using VIBR or WATR. That would make me change a lot of things in the design too.
  • King36C
    King36C     17th May 2019
    Kinda fixed the problem by increasing size of the switchers. Still breaks sometimes so i'll gotta change it anyway but thanks you all for your help :)
  • Lampbulb_
    Lampbulb_     15th May 2019
    yup, tested it out with the orighinal temp with dmg. it melted. but then i tried it with negative temps, and it didn't melt.
  • F1R3X
    F1R3X     15th May 2019
    (i tested and the reactor exploded)
  • F1R3X
    F1R3X     15th May 2019
    I tryed this id:2421596
  • martin1
    martin1     14th May 2019
    the pressure broke the WIFI into BRMT which made it conduct heat to the PSCN. try stoping the pressure and heat by puting TTAN between INSL
  • Scien_Tific
    Scien_Tific     14th May 2019
    I know what's going on. The pressure breaks the WIFI which then transfers it's heat to the PSCN. You need TTAN to stop the pressure. What you could also do is set the PCLN futher away and make a small channel that leads to the reactor, or PIPE.
  • Lampbulb_
    Lampbulb_     14th May 2019
    wait, why do you need to fill it with boyl anyways? it could have been pre-added.
  • Lampbulb_
    Lampbulb_     14th May 2019
    hmm, It may be a glitch. when the uran and boyl hit 100C, the pscn melted to 4000C. try adding a sort of cooling system and set the wifi to lower temps. the wifi also breaks so that needs ttan around it, but the only soloution I can see with this "glitch" is to remodel it and make it all come out from 1 or 2 nozzles. It will make it easier to cool.