Dual Loop Pressurized Water Reactor by dornog70

dornog70

103 / 7

6th February

26th October

A Uranium Fueled 2 Loop Pressurized Water Reactor with 3 buildings that simulates all 3 loops somewhat realistically, along with auxilary and safety equipment. Ideal core temperature band 270-300C. Best viewed in fire display.

realistic uranium pwrs water power reactor pressurized uran nuclear bomb

Comments

• 

  NuclearPerson 5:48:59
  ever considered a nuclear engineering degree...?
• 

  pickle4L17 25th October
  ok (comment too short)
• 

  dornog70 25th October
  later when i add MSIVs ill make it isolate the steam lines when theres high condenser outlet temperature
• 

  dornog70 25th October
  the steam from bypass is hotter than steam from the turbine, so it might overheat the condenser
• 

  dornog70 25th October
  thats fine
• 

  pickle4L17 24th October
  When the steam goes into the condenser from bypass line it hits the detector and produces electricity
• 

  pickle4L17 24th October
  Um... that's a lot?
• 

  dornog70 24th October
  it takes a while to warmup the turbine, so you could just directly skip the warmup part if you wanted to (keep MSR valve open while turbine is online)
• 

  dornog70 24th October
  measure the temperature of the turbine shell from the edge of the right side of the MSR
• 

  dornog70 24th October
  stop the RHR, start the reactor and maintain the core temperature at ~340C, wait for steam generators to start boiling sufficiently and steam to start flowing through the bypass line, then open the MSR valve to heat the shell of the turbine, from there wait until the shell of the turbine is approx >250C, after its warm open the turbine and close the bypass