Dual Loop Pressurized Water Reactor by dornog70
A Uranium Fueled 2 Loop Pressurized Water Reactor with 3 buildings that simulates all 3 loops somewhat realistically, along with auxilary and safety equipment. Ideal core temperature band 300-370C. Best viewed in fire display.
energy
uranium
pwrs
water
power
reactor
pressurized
uran
nuclear
realistic
Comments
-
dornog70 8th Dec 2025
steam from bypass line will always be hotter than steam from the heater drains/turbine exhaust -
dornog70 8th Dec 2025if your MSIVs isolate due to the condenser overheating, make sure your not using the bypass for too long. let the condenser heat sink cool down, you can use the condenser makeup to assist with this. after that perform previous steps to open MSIVs and restore main condenser as a heat sink
-
dornog70 8th Dec 2025MSIVs will also automatically isolate upon high main condenser temperature
-
dornog70 8th Dec 2025verify no present LOCA signals>hold ECCS logic reset push button (next to blue ECCS actuation button)>under containment isolation panel, hold OPEN (O) on MSIVs
-
jakegrant0902 8th Dec 2025
ok question how do i disable MSIV activation after turning it on -
dornog70 6th Dec 2025I might reduce the total gel inventory to prevent total flooding of the RCS during ECCS injection
-
dornog70 6th Dec 2025disregard this if there is a primary system break, in a LOCA the flow of coolant rushing out and emergency coolant rushing in cools the reactor already.
-
dornog70 6th Dec 2025make sure when using ECCS, do not flood the primary system. otherwise heat will not be removed effectively from the reactor core. ensure that there are no present LOCA actuation signals, then HOLD the reset (RST) button to the left of the ECCS actuation button. From there, turn off the ECCS on the safety panel.
-
mellowmonster12 5th Dec 2025
someone tagged this bomb -
TPT_Idiot 5th Dec 2025
about to give dornog70 a Nobel prize for this save