The Powder Toy

NEW AESTENSIUM INFO. by jansuki

jansuki
jansuki
17 / 1
26th June
26th June
The reactor shown works by detecting if the heat is too low, if it is, the aestensium is released heating it up, and then is put back in the stor a few frames later.
aest

Comments

  • netherpro
    netherpro     1st July
    The only defect is its low capacity,as any temp below lava melting point would kill aestensium.Maybe adding a buffer would be better
  • FoxFries404
    FoxFries404     30th June
    KyleTheCreator: May I present P T C T ?
  • KyleTheCreator
    KyleTheCreator     30th June
    wait wait, use TWO! [the power of two!!!!] AEST reactors which when the first one runs out of heat of watr, the next one activates! using. DLAY.
  • FoxFries404
    FoxFries404     29th June
    As they said, it cools less fastly, so it's better.
  • jansuki
    jansuki     29th June
    2.2*10^24 years for tellurium-128
  • jansuki
    jansuki     29th June
    frzw cools less fastly (oh theres a word for that) than a watr turbine
  • wisco11
    wisco11     29th June
    this is nothimng compared to tellurium 128's half life
  • KyleTheCreator
    KyleTheCreator     29th June
    as once jansuki said. "FRZZ good, watr BAD" -jansuki
  • Verycreativedude
    Verycreativedude     29th June
    why not just aestenium to heat the water up?
  • jansuki
    jansuki     28th June
    nice one!