top 3 best ways to make heat in tpt by Fusi0n

Fusi0n

2 / 0

13th September

14th September

credit to bestcrafter29zb for the podium and if u think i made a mistake, tell me and make sure to tell me what placement it should be, and no prop tool allowed, only walls and particles(should i put pressure+ uran?)

fusi0n heat bomb laser destructive rank ranking newbrotherhood

Comments

• 

  Fusi0n 14th September
  jakav: u got a point, there is no top but one thing, vibr heat takes while, but u still got a point
• 

  Jakav 14th September
  Deserialization makes heat. Also, consider URAN, molten plutonium, VIBR heat generation, and GOL heat generation. Ranking is entirely situational, so this "top 3" is really just three of the possible ways, not the ones at the top, because there is no top.
• 

  KyleTheCreator 14th September
  Fusi0n: You also need hest to begin with with URAN too
• 

  KyleTheCreator 14th September
  Pure warp takes over EXOT
• 

  Fusi0n 14th September
  prop tool is a tool, not a particle or wall also again, u already need heat 2 begine with for the 9725.85 insl to make the -273.15 particle into that temp, i mean make ehat out of thin air, if the insl was -273.15 it wouldnt make the particle 9725.85
• 

  KyleTheCreator 14th September
  warp with high tmp can get to 9725.85C in like LESS THAN A SECOND
• 

  KyleTheCreator 14th September
  also what about prop tool?? it can control ANY value
• 

  KyleTheCreator 14th September
  out of THIN, AIR
• 

  KyleTheCreator 14th September
  Are we forgetting that a tsns tmp 1 one 9725.85C insl and one more tsns with tmp 3 and a single piece of flit csn make a single -273.15C particle into 9725.85C in a SINGLE TICK
• 

  KyleTheCreator 14th September
  Fusi0n: : ||