The Powder Toy

HYGN BOILER GENERATOR by Umazachi_TPT

Umazachi_TPT
Umazachi_TPT
5 / 1
2nd October
2nd October
This is my attempt at making a boiler generator that burns hydrogen to make power. To start the loop, open the the divider (check top left) and let it run for some time. If the cooler loop goes above 100C, use the cooling option. Can start manually too.
hygn boiler generator newbrotherhood

Comments

  • Umazachi_TPT
    Umazachi_TPT     12:33:56
    This could also operate with BCOL but its naturally a lot slower. Somehow, the pressure inside the Boiler is higher with BCOL? When I tried it, HYGN gets it to around 55 ish but BCOL consistently hits 70? Any idea how that works?
  • Umazachi_TPT
    Umazachi_TPT     8:38:59
    gabriel_ultrakill> yea haha
  • Umazachi_TPT
    Umazachi_TPT     8:38:49
    Thereactorguy2054v2> Thank you
  • gabriel_ultrakill
    gabriel_ultrakill     6:11:09
    so much glow... yet no flow.
  • Thereactorguy2054v2
    Thereactorguy2054v2     2nd October
    But for basically a kinda first, pretty good.
  • Thereactorguy2054v2
    Thereactorguy2054v2     2nd October
    I suggest making the door pull a bit back more possibly, And use ptct instead of convert, Because I noticed it eats a lot of water. Also the LN2 can cause the water to freeze during normal operations
  • Umazachi_TPT
    Umazachi_TPT     2nd October
    XD mbg
  • Builderbob101
    Builderbob101     2nd October
    the snapshot for the thumbnail flash banged me +1
  • Umazachi_TPT
    Umazachi_TPT     2nd October
    if you want to start it manually, you will have to clear the pressure, wtrv, watr, hygn and set ctype of clne to none. After that, you fill the boiler or the tank with watr and use hygn in the fuel chamber. Quickly press the start button, and give it a minute to warm up. After that, you can open the divider.