I made a second version of my bomb analyser and I need to test it.

Would anybody interested in testing it and then write a short (or longer, if you want :P) feedback and/or improvements here?

Here is the save: (unpublished)

I think it is easy to understand and use:

Spark the green button to start the graphs and if you spark the red one, it will stop plotting and refreshes the graphs automatically, so they won't disappear (because they are made of BRAY ;-) ).

These buttons are on the left near the reversed pyramidal thing.

Then place anything hot or that makes negative/positive pressure or changes newtonian gravity in the box with walls and sensors around it.

The graphs will show how the temperature and the pressure are changed over time. If the graphes are full, it will be deleted and it starts immediately at the beginning.

Even if you use GBMB (or anything else what makes newtonian gravity), this will be dedected and then the two lines in the lower graph boxes wil go up or down. There are two gravity graphs, because gravity is measured at the left and at the right side of the box.

The gravity graphs need some time to startup, when it is started, you see three pixels over each other (usually in the middle ot the graph box). The gravity sensor unit needs also time to finish their work (if you stop the graphs), so you can't start the graphs immediately after stopping it, otherwise the whgole high-speed graph plotting system would crash extremely and that is really bad.

(if you want to see the graph system crashing, put anything in the graph boxes)

I think, i explained the main things you must know, so... HAPPY TESTING!

I figured out, why DEUT bombs sometimes crash it: DEUT bombs create lots of neutrons and reach the maximum particle limit, so no neccesairy BRAY can created and it goes crazy.

I added a reset button for that case to reset the graph system. (the button on the right with the blue arrow)