Wifi keeps failing in plasma cutter -.-
-
1212997View Save 1212997
If you run it too long the wifi melts (?). It is usually the bottom electrode and/or the box in the middle that feeds power to the electrodes via wifi. The wifi just, stops, turning into broken metal. I'm not very experienced, so what might stop this?
-RCAP
-
Turn air sim off, the wifi doesn't melt it breaks.
-
Don't say: please give credit/votes. And also don't say: this is 100% my own, it's suspicious.
-
kk
-
@RCAProduction (View Post)
Wifi doesn't conduct heat as it's channels are based on it's temperature. This means wifi cannot melt. But it does break under gravity/pressure. When i tried none of the wifi broke. There was pressure created but it was not enough to break the wifi.
@hittox (View Post)
Asking to give credit if copied is perfectly legal. He didn't ask for votes. -
But he said: ''Please give credit'', Not please give credit if you copy
-
-
I just couldn't resist posting this image. -
lol
Just keep the cutter on, or put some ttan in to be melted... It will fail, most of the time.
And, yes, it is the pressure. How would I depressurize? Air passing block?
-
